NEO CABLES

Line / Microphone Cables

PA-02 V2 Series

  • Recording
  • Microphone
  • audio,speaker
  • Keyboards
  • Guitar&Bass

PA-02 V2 Microphone Cable for Professional Recordings

To be considered studio quality, we believe a microphone cable needs to be hi-resolution, informative, quick-response, and provide a wide frequency range for high quality sound recording.
“PA-02 V2 series” fulfills the demands of sound engineers, producers, players and all sound creators who pursue higher quality in the recording studio.
PA-02 V2 carries a low-noise, clean, high sensitivity, wide range signal. Special noise protection and vibration damping properties of the cable reduce signal loss and distortion.
The PA-02 brings the best out of a high quality microphone in both recording and AES/EBU digital signal transmission at an impedance of 110 ohm.

SPEC

The copper of the PA-02 V2 is 102 SSC which is produced by Oyaide Elec. It shows an incredible conductivity level of 102.3% IACS (after annealing process).
The copper base material for the 102 SSC is refined in Japan and conforms to the elite Japanese JIS C1011
industrial standard. Only pure virgin copper base is used. It does not contain any recycled
material. Also, we have employed mechanical peeling – a very precisely controlled process that removes 100% of impurities. We also choose to use natural diamond dies over synthetic diamond
dies which yield more uniform volume reduction with reduced stress and improved lubricity.
The 102 SSC wire’s surface structure is far superior to all others. It has an outer diameter accuracy of ±1μm, far exceeding the ±0.8μm in Japanese standards for conventional copper wires.
The conductor structure of PA-02 V2 is created by a process called three element stranding. 3E stranding combines strands of three different diameters to increase the density of the wire by decreasing the spaces between strands. This results in a smaller outer diameter than the same gauge wire made with identical individual strands, plus a more accurate, stable, and perfectly circular cross section.

CONDUCTOR 102SSC 18 AWG(19 pieces of 3 Element stranding)
INSULATOR Foamed polyethylene
SHIELDING braided 102 SSC
INNER INCLUSION Low Density Polyethylene
OUTER halogen-free sheath for audio
SOLDER OYAIDE SS-47
PLUGS XLR:Switchcraft AAA / 1/4 TRS Phone jack:NEO P-285T
CHARACTERISTIC IMPEDANCE 110Ω

LINEUP

PA-02 V2 XLR
XLR MALE - FEMALE

1.0m / 2.0m / 3.0m / 5.0m

PA-02 V2 TXM
TRS - XLR MALE

1.0m / 2.0m / 3.0m / 5.0m

PA-02 V2 XFT
XLR FEMALE - TRS

1.0m / 2.0m / 3.0m / 5.0m

PA-02 V2 TRS
TRS PHONE - TRS PHONE

1.0m / 2.0m / 3.0m / 5.0m

PA-02 V2 TS
XLR MALE - FEMALE

1.0m / 2.0m / 3.0m / 5.0m

PageTop